Executing The Reset Methods - HP 10:10 LAN Bridge MB Installation And Reference Manual

Executing the Reset Methods

To execute any of the reset methods, follow the appropriate procedure below.
REset Command
Enter RE from the Main prompt on the bridge console.
Reset Button
Press the button labeled Reset on the back on the bridge. The Pwr, Self-test, and Net Fail LEDs
stay on while this button is pressed. The reset process starts when the button is released.
Cycle Power
The bridge does not have a power switch. To cycle the power on the bridge, unplug the power
cord from the bridge and then plug it back in. Note that this process has the same effect as the
reset button. The reset button is the preferred method.
Reset-Clear
1. Simultaneously press the two buttons labeled Reset and Clear on the bridge.
The Clear button is recessed. To press it, use a non-conducting pointed implement like
a toothpick.
2. Release the Reset button and continue holding in the Clear button until the LED labeled
Self-test begins to flash.
3. Release the Clear button.
Note
Pressing the Clear button by itself causes the bridge password to be erased. See
"Clearing the Bridge Password" later in this chapter.
Operation 4-13