Mount The Bridge - HP 10:10 LAN Bridge MB Installation And Reference Manual

1. Mount the bridge

1. Make sure the bridge's power cord is correct for your country's ac power supply. Do
not plug the power cord into the power supply until the bridge is mounted. (Note that
the bridge does not have a power switch; the bridge is powered on when the power cord
is plugged in.)
2. As described on the next page, mount the bridge in a rack or on a wall by using the
mounting brackets, or place it on a table.
Before mounting the bridge, plan its location and orientation relative to other devices and
equipment. Also consider management of the cabling you will be attaching and consider access
to the ports you will be using. In the example below, the bridge is mounted in a rack with other
HP EtherTwist family devices and a cable guide unit. Order the HP EtherTwist LAN Rack (HP
46298D) and the Cable Guide (HP 35199D).
Cable guide
Thin coaxial cable
backbone
2-2 Installation
HP network
devices; hubs,
bridges, etc.
Standard 19-inch
telco rack