Configuring The Camera With The Camera Configuration Tool Plus (Cct+); Opening The Configuration Tool; Closing The Configuration Tool - Basler A500k User Manual

Configuring the Camera
4.1 Configuring the Camera with the Camera
Configuration Tool Plus (CCT+)
The camera configuration tool CCT+ is a Windows
camera's settings. The tool communicates via the RS-644 serial connection in the Camera Link
interface between the frame grabber and the camera. The tool automatically generates the binary
programming commands that are described in Section 4.2. For instructions on installing the tool,
see the installation booklet that was shipped with the camera.
This manual assumes that you are familiar with Microsoft Windows and that you have a basic
knowledge of how to use programs. If not, please refer to your Microsoft Windows manual.

4.1.1 Opening the Configuration Tool

1. Make sure that the properties for the RS-644 serial port on your frame grabber are properly
configured and that the camera has power.
2. To start the CCT+, click Start, click Basler Vision Technologies, and then click CCT+
(default installation).
During start-up, a start-up screen can be seen.
If start-up is successful, the tool will open. To familiarize yourself with using the tool, press the
F1 key and look through the online help included with the tool.
If an error occurs, the tool is automatically closed after start-up. Refer to the CCT+ Installation
Guide for possible causes.

4.1.2 Closing the Configuration Tool

Close the CCT+ by clicking on the
4-2
PRELIMINARY
button in the upper right corner of the window.
™
based program used to easily change the
k
Basler A500