Table of Contents
Advertisement
Configuring the Camera
4.2.4.11 Area of Interest Starting Line
Purpose:
To set the starting line for the Area of Interest or to read the current starting pixel setting.
See Section
Type:
This is a read or write command.
Read Command:
Response:
Write Command:
Response:
Data Format:
Data Range:
4.2.4.12 Area of Interest Height in Lines
Purpose:
To set the height in lines for the Area of Interest or to read the current height setting. See
Section
Type:
This is a read or write command.
Read Command:
Response:
Write Command:
Response:
Data Format:
Data Range:
4-18
PRELIMINARY
3.9
for details.
Cmd-ID
R/W-Flag
0xA8
Cmd-ID
R/W-Flag
0xA8
Cmd-ID
R/W-Flag
0xA8
None
Byte 1
Low byte of the starting pixel setting
Byte 2
High byte of the starting pixel setting
The starting line setting can range from 0x0000 to 0x03FF. For color
cameras, it can only be set in steps of 2. (Note that the starting pixel = n +1
where n is the value of the starting pixel setting.)
3.9
for details.
Cmd-ID
R/W-Flag
0xAA
Cmd-ID
R/W-Flag
0xAA
Cmd-ID
R/W-Flag
0xAA
None
Byte 1
Low byte of the length in pixel setting
Byte 2
High byte of the length in pixel setting
The height in lines setting can range from 0x0002 to 0x0400. For color
cameras, the height can only be set in steps of 2 starting at 0x0002.
Data Length
1
2
Data Length
0
2
Data Length
0
2
Data Length
1
2
Data Length
0
2
Data Length
0
2
Data
-
Data
2 Bytes
Data
2 Bytes
Data
-
Data
2 Bytes
Data
2 Bytes
k
Basler A500
Advertisement
Table of Contents
Troubleshooting
