Before Operating; Procedures Before Starting; When Starting - Volvo EC330B Operator's Manual

Before operating

Procedures before starting

IMPORTANT
Always walk around the machine before starting and check
that there are no persons in the immediate vicinity of the
machine.
1 Place the machine in the service position. See Service posi-
tion on page 120.
2 Carry out daily maintenance. See Lubrication and service
chart on page 172.
3 Adjust the seat so that you comfortably and safely can operate
all controls and pedals.
4 Check instruments and control lamps. See Checking instru-
ments, warning and control lamps on page 95.
5 Check that head lamps, windscreen wipers/washer, reflectors
etc. are in a serviceable condition.
6 Check that there are no leaks.
7 Check that there are no faulty or loose parts which can cause
damage.
8 Check that there is fuel in the tank*
9 Check that engine hood and guard plates are closed.
* If the fuel tank has been run dry or if air for any other reason has
entered the fuel system, this must be bled before the engine can
be started. See Bleeding fuel system of air on page 138.

When starting

1 Clean/defrost the windows.
2 Always sit in the operator seat when you are starting the en-
gine/the machine, See Starting engine on page 96.
3 Fasten the seat belt before all operation.
4 Do not move off until the central warning lamp has gone out.
5 Check that all gauges, controls and instruments are function-
ing.
6 Check that no persons are near the machine before you move
the machine.
7 Sound the horn.
8 Finally, move the safety locking lever up to be able to operate
the working and travelling hydraulics.
Operating instructions
93