Replacing Bucket Teeth; Standard Type (Transverse Pin), K-Bucket - Volvo EC330B Operator's Manual

A
D
A
B,C

Replacing bucket teeth

Replace the bucket teeth before the adaptors wear away.
WARNING!
When changing the bucket teeth, always:
Lower the bucket to the ground, position to the easiest
posture for working, stop the engine.
Place a block (A) under the bucket, then lower the bucket keeping
it horizontal.
Stop the engine and Put the safety locking lever down to lock
the system securely, See Safety locking system on page 60.
WARNING!
Before removing the locking pins always wear eye
protection.
S80293A

Standard type (transverse pin), K-bucket

1 Drive out pin (B) using a hammer and punch, being careful not
to damage lock washer (C).
•
Use a round bar with a smaller diameter than the pin as a
punch.
2 Clean the surface of adapter (D), insert a new lock washer (C)
in the correct place, and install a new tooth (A).
3 Drive pin (B) into the pin groove, through lock washer (C) until
the pin is flush with the tooth.
S80294A
Service and maintenance
Replacing bucket teeth 169