Table of Contents
Advertisement
Presentation
24
Service
Service
General
If the machine is to operate as economically as possible, it must be
thoroughly maintained. Intervals for maintenance and lubrication
apply to the machine under normal environmental and operating
conditions. The maintenance work described in this Operator's
Manual is carried out by the operator. Further adjustments and re-
pairs should be carried out by an authorized dealer workshop.
Delivery inspection
Before the machine left the factory, it was tested and adjusted. Be-
fore delivery to you, the dealer carried out an additional further
check, "Delivery Inspection", according to our instructions.
Warranty inspection
It is important that during the first period of operation the machine
is subjected to further checks, such as check-tightening of bolts,
checking settings and other minor adjustments.
Therefore, two warranty inspections should be carried out. The
first after 100 operating hours and the second at 1000 operating
hours.
The times for these inspections may be changed by Volvo Con-
struction Equipment without prior notice.
Maintenance service
Condition test and maintenance programme
In addition to actions which are taken according to the mainte-
nance program in the manual, the authorized dealer workshop can
offer a maintenance system, based on condition tests which give
information about the general condition of the machine.
Further information about these systems can be obtained from the
nearest authorized dealer workshop.
Hide quick links:
Advertisement
Chapters
Table of Contents
