After Operating; Stopping Machine; Stopping Engine - Volvo EC330B Operator's Manual

S83367

After operating

WARNING!
When you are entering and leaving the machine, always
face the machine and use the steps or hand holds to avoid
slipping. Always use the three-point stance, i.e. two hands
and one foot or two feet and one hand when climbing up
onto or descending from the machine. Do not jump!

Stopping machine

IMPORTANT
Select level ground to park the machine.
1 Put the left and right operating levers to neutral position.
2 Turn the engine speed control switch to low idle speed posi-
tion.
3 Lower the bucket to the ground, keeping the bottom of the
bucket parallel to the ground.
4 Move the safety locking lever down to lock the hydraulic
system securely. See Safety locking system on page 60.

Stopping engine

IMPORTANT
Run the engine at low idle speed for a few minutes before
stopping it to safeguard lubrication of the turbocharger.
1 Turn the starting switch to stop (
NOTE :
If the machine is to be left for any length of time, the current
should be turned OFF with the battery master switch. See
Long-term parking on page 102.
Rotating beacon lamp (option)
When transportating the machine, dismantle rotating beacon lamp
A
(A) not to be damaged.
1 Dismantle the rotating beacon lamp (A) with loosening the
wing nut (B) Looesn the wing nut (B) and dismantle the rotating
B
C
beacon lamp (A).
D
2 Keep the rotating beacon lamp (A) in the cab during transpor-
tation.
Put the rubber cover (C) on the bracket (D).
Operating instructions
After operating
) position
101