Hardware Assembly; C1. Changing Voltage On Dreamer Power Supply - Flashforge DREAMER User Manual

C.

HARDWARE ASSEMBLY

The Dreamer comes pre-assembled and is almost ready-to-print (ARP).
All you need to do is set the appropriate voltage, mount the extruder
set, and install the filament. It will only take between 5 to 10 minutes
before you can fire up the Dreamer and prepare for your first 3D print!
PRECAUTION:
FlashForge Dreamer uses a switching power supply with 115V/230V. Prior to
installing the hardware, it is critical to check the AC output voltage of your
home or workplace. The power supply should be switched to reflect your AC
output voltage. Failure to do so will cause severe damage to the Dreamer.
Please follow the steps below to switch to the correct voltage.
For the United States and Canada, the correct voltage to use is 115V. For most
European countries, use 230V.
will not be responsible for damages as a result of improper care.
Changing Voltage on Dreamer Power Supply
The power supply is located at the bottom of the Dreamer. It is accessible by
removing the four screws
the Dreamer with the front panel facing down. Hold the extruder set while doing
this. You will see the power supply switch. Using a hex wrench, switch it to the
appropriate voltage for your country. Replace the bottom panel and secure it back
on with the original screws.
Dreamer User Guide | www.flashforge-usa.com
Please double-check as FLASHFORGE USA
with the supplied hex wrench. To do this, gently rest
14