Martin P3-100 System Controller Installation And Safety Manual User Manual page 16

Toolbar
The following commands are available in the toolbar at the top of the screen:
16
Opens the File menu, where you can open a configuration, back up a
configuration to a USB memory device, close a configuration, etc.
Undo/redo buttons for the last actions you performed. 20 levels of undo
are available. Commands sent by DMX cannot be undone.
Opens the Setup view where you configure fixtures and place them on
the canvas.
Opens the Video Input view. This is where you configure the video input
to the P3-100 and all other video parameters.
Opens the Remote Control view. This is where you configure DMX
control functionality.
Opens the Live view. This is the view typically used when a show is
running. It provides real time status feedback to the user.
Enables / Disables the Hand tool, which lets you 'grab' and move the
canvas.
Lets you zoom in / out on the canvas. TIP: you can also zoom in and out
by holding Ctrl pressed and using the scroll wheel on the mouse.
Activates the Wizards submenu, which lets you activate one of the
intuitive wizards.
Enables / Disables screen blackout. TIP: if you are unable to display
video on the panels, check that this button is not pressed.
Enables / Disables a screen freeze. This lets you "freeze" the video
currently running on the panels.
The button allows you to enable / disable test pattern display on the
panels. The pull-down menu allows you to select test pattern type.
Activates the Tools submenu, which lets you jump into one of the
Settings windows.
Lets you shut down or reboot the P3-100 System Controller.
P3-100 user manual