Getting Started with SmartWorx
4.9.4
Working in Semi-Transparent Mode
Description
Access
step-by-step
<ComMode: Semi-Transparent> enables the total remote control of TPS in RCS
mode but the data being captured by TPS will be sent via radio link to the LEMO port
of RX. A computer connected to this port will receive the data captured on TPS in
real-time.
Data being sent over the radio link in this mode is not protected by a Leica protocol.
There exists a chance of data loss without notification.
Description
From CONFIGURE Interfaces on TPS ensure that GSI Output and
RCS Mode are turned on.
Proceed to the local menu of RX.
1. Select Main Configuration Menu: Radio/Comms Settings, Modes page.
2. Set <ComMode: Semi-Transparent>.
RX1200
108