Nomadix HotSpot Gateway HSG User Manual page 72

Blocking or unblocking interface access will terminate the current
session.
Do not enable the blocking of all interfaces without setting up and
enabling SNMP. Enabling the blocking of all interfaces and disabling
SNMP will completely block access to the HSG administration
interface. For assistance, contact Nomadix Technical Support.
Click the check box for
3.
click on the
Submit
If you enabled Access Control, administrator access is restricted only to the IP
addresses shown under the "Currently Access is Permitted for IPs" listing. If you
want to add to or remove IP addresses from the list, go to Step 4 through Step 8.
The Access Control list can contain up to 50 (fifty) valid administrator
IP addresses or up to 50 (fifty) ranges of IP addresses.
To add an IP address (or range of IP addresses) to the list, enter the "starting" IP
4.
address in the
Access Control Start IP
If you are adding a range of IP addresses to the access control list, you must now
5.
enter the "ending" IP address in the
adding a single IP address, enter "None" in the Access Control End IP field.
Click on the
6. Add
list.
To remove an IP address (or range of IP addresses) from the list, enter the
7.
"starting" IP address in the
If you are removing a range of IP addresses from the access control list, you must
now enter the "ending" IP address in the
removing a single IP address, enter "None" in the
Click on the
8. Remove
from the list.
If you enabled Access Control and have "locked yourself out," of the
system (for example, because you've forgotten your password), you
must establish a local serial connection with the CLI to disable the
Access Control feature, or change the range of allowed IP addresses to
access the management interfaces. If you have changed the serial port
to act as a PMS interface, please contact Nomadix technical support. In
this case, refer to
68
if you want to enable this feature, then
Access Control
button to save your change.
field.
Access Control End IP
button to add the IP address (or range of IP addresses) to the
Access Control Start IP
Access Control End IP
button to remove the IP address (or range of IP addresses)
"Contact Information" on page
H S G
OT POT ATEWAY
field. If you are
field.
field. If you are
Access Control End IP
259.
System Administration
™
field.