PSC Falcon PT40 Product Reference Manual page 98

Programming Parameters
Alternate Parameters for the Falcon PT40
Enter these commands by scanning the bar codes with the PT40's laser or
through the PC's serial port. With PT Program Generator (PPG), you can
embed these codes in a PPG application.
The Falcon PT40 recognizes the following bar code commands at all times:
Table E-3. Scannable Bar Codes of Alternate Settings for the PT40
Setting Name
Clear Mode
Character
Clear Mode
High Beep
Mode
Low Beep
Mode
Receive File
Mode
Retrieve Data
Mode
CAUTION
E-4
Scannable Bar Codes of Alternate Settings for the PT40
Bar Code
*--*
*-+*
*.+*
*.-*
*/.*
*$$*
*+.*
Reset Mode
Description
Has the same effect as the
Has the same effect as the
acter entered.
Sounds a high beep on the PT40.
Sounds a low beep on the PT40.
Prepares the PT40 to accept a program.
Retrieves data if the application program stops execution
and gives the
PROGRAM FAILED
the PT40 to the PC and start the communications pro-
gram on the PC, then scan this bar code. The data will
transmit, one file at a time.
Clears all memory and resets the PT40.
key
<CLR>
key for the last char-
<CLR>
message. Connect
®
Falcon PT40