PSC Falcon PT40 Product Reference Manual page 76

PT40 Dock, Serial Cable, and Power Adaptor
When the PT40 is in the Dock, and the Dock is connected to a PC, you can
download programs or data to it, or upload data from it.
Serial Cable
The serial cable works much like a dock, in that you can use it to transfer data
or charge the PT40's main battery.
•
•
Figure B-2. Falcon PT40 Serial Cable
9-Pin Serial
Connector
Power Adaptor
To recharge the PT40's batteries, the Power Adaptor is also required. You do
not need a Power Adaptor to transfer data using the serial cable, but it is
required to transfer data using the Dock.
Use only a 9-volt power adapter for your country supplied by PSC. The use of
another adapter can damage the PT40 and void your warranty.
The EU connector is shown in
country, the power supply may look different. For the correct adaptor for the PT40
CAUTION
for your country, refer to the PSC Price Book at
The power adaptor is AC input rated 100 to 240 VAC (50--60 Hz); Output =
9 VDC @ 1.3A.
B-2
To transfer data, set up the PT40 and serial cable as described in
ing the PT40 to a PC page B-3
To charge the PT40's batteries, connect the PT40, serial cable, and
power adaptor to a 110-volt outlet or power strip.
.
Power Adaptor
Connector Jack
Figure B-3 on page B-3
www.pscnet.com
Attach-
Docking Port
Connector
Serial Cable
. Depending upon your
.
®
Falcon PT40