PSC Falcon PT40 Product Reference Manual page 71

Figure A-4. Charging the Main Battery in the Charging Slot
4. Attach the small, round plug of the 9-volt power adapter to the round
5. Plug the power adapter into a wall outlet or a power strip. The LED on
Using the PT40 Dock (PT40 Unit)
To recharge the PT40 using the PT40 Dock, leave the main battery in the
PT40 and complete the following steps as shown in
1. If the PT40 is on, turn it off.
If the PT40 remains in the dock for an extended period of time, the charger in the PT40
will cycle (several hours per cycle) between charged (green LED) and charging (red
LED) to keep the battery topped off.
2. Place the PT40 into the docking space in the PT40 Dock.
3. Attach the small, round plug of the 9-volt power adapter to the round
Product Reference Guide
power input jack on the 9-pin connector at the end of the Dock's cable.
the left front of the Dock will be red while it is powered.
power input jack on the 9-pin connector at the end of the Dock's cable
as shown in
Figure A-5 on page A-6
Recharging the Batteries
Step 3
Figure A-5 on page A-6
.
:
A-5