PSC Falcon PT40 Product Reference Manual page 77

Figure B-3. Falcon PT40 Power Adaptor
Attaching the PT40 to a PC
Use PT40 Dock or Serial cable to connect the PT40 to a PC. The PT40 9-volt
power adapter is required in conjunction with the dock or serial cable to
recharge the main battery on the PT40.
To connect the dock to a PC, complete the following steps:
1. Turn off the PC or workstation.
2. Attach the 9-pin serial connector of the Dock's cable to an available
3. Insert the small, round plug of the power adapter to the power adaptor
4. Place the PT40 into the dock, with the keypad facing out, or insert the
5. Connect the PT40's 9-pin Serial Adaptor into the PC's COM1 or
Product Reference Guide
9-Volt Power
Adaptor
Power Connector
Power Plug
Power Cord
serial port on the PC. Make note of which one you use.
jack on the back of the 9-pin serial connector on the Docks' cable. (Refer
to .)
Figure B-4
docking port connector of the serial cable, into the matching port at the
bottom of the PT40. (Refer to
COM2 Serial port. (Refer to
Attaching the PT40 to a PC
and
Figure B-1 Figure B-2
.)
Figure B-1
.)
B-3