Pt40 Belt Clip - PSC Falcon PT40 Product Reference Manual

To recharge the PT40's batteries and for more detailed information about the
main and backup batteries, refer to
Using the Dock to Recharge the Main Battery on page B-4

PT40 Belt Clip

To install the belt clip, complete the following steps:
1. Follow the instructions for
Figure 1-5. Belt Clip and Knob Assembly
2. Align the belt clip knob with the slight depression just above the battery
3. Replace the battery and battery compartment cover as described in
4. Slip the belt clip knob (refer to
5. Attach the belt clip to your belt.
6. To release the unit from the belt clip, press the button at the top of the
Product Reference Guide
remove the main battery and battery cover door.
compartment.
• Position the knob facing out and the small clip lined up with the
small slot inside the unit. (
• Press up firmly on the belt clip to insert it into the slot (refer to
for the location of an installed belt clip knob).
Figure 1-6
Battery Installation starting on page A-3
belt clip and slip the unit up from the slot.
Falcon PT40 Batteries on page A-1
Main Battery Installation starting on page A-3
shows the belt clip knob)
Figure 1-6
.
) into the slot in the belt clip.
Figure 1-6
Accessories
and
.
to
Release
button
Belt Clip
Slot
Belt Clip
Belt Clip Knob
Main
1-13