Setting Up The Pt40; Getting Started - PSC Falcon PT40 Product Reference Manual

6. Enter a password. (Refer to
7. Press any function key to continue on to the
8. Press the
The PT40 is now ready to begin collecting data. For information about
sending collected data from the PT40 to a PC, refer to
Host PC starting on page 3-2

Setting Up the PT40

You can collect data records on the PT40, and send the records later to a host
PC. The number of data records that can be collected before being uploaded
depends on how much random-access memory (RAM) is installed in the
PT40.
The PT40 stores data records in files in random-access memory (RAM). The
number of records that can be collected depends upon the amount of RAM
available to the application. Refer to the
mine the amount of RAM you need.

Getting Started

Unless it has been customized, the Falcon PT40 is programmed from the fac-
tory for basic data collection using
This chapter describes how to use the PT40 with its original PSC programming
(i.e.
Check with a systems administrator for revised operating instructions.
If the PT40 does not turn on when the
recharge the main battery (refer to
Product Reference Guide
key to display the list of available applications. Select the
<F2>
application to use. (Refer to
.)
on page 2-9
). If the PT40 has been customized, it may operate differently.
PALPRO40
Setting a Password on page 2-6
Switching to Another PALPRO40 Application
.
Memory Table on page F-1
.
PALPRO40
key is pressed, you many need to
<PWR>
Falcon PT40 Batteries starting on page A-1
Setting Up the PT40
.)
menu.
PALPRO40 Options
Uploading Data to the
to deter-
).
2-3