Transferring Files and Data
Connection
Baud Rate
Protocol
Maximum Errors Enter the maximum number of
Flow Control
Window Size
3-4
Enter the
Connection
of detected serial ports or modems.
Select a
Baud Rate
tions from the pull-down list. The default
value for XFER32 is
value for the PT40 is
Note: The PT40 supports only baud rates
38400
up to
Select either
the file transfer
receiving files.
ZModem
NOTE:
ported by the Falcon PT40.
NOTE: The PT40 defaults to the
XModem
select
ACK/NAK
supported by the PT40.
transfer is aborted. Range:
number of file transfer errors.
Select the mechanism used to control the
flow of data. Sender and receiver must
agree on the flow control method.
RTS/CTS
Note:
XON/XOFF
None
No flow control used.
ZModem
XON/XOFF
NOTE:
This feature is only available with
RTS/CTS
Hardware flow control that uses
Clear to Send
suspend and resume data transfer.
ZModem
NOTE:
This feature is only available with
port for file transfers. Select from the list
for serial communica-
19200
. The default
9600
.
.
XModem
ACK/NAK
or
for sending and
Protocol
Protocol is NOT sup-
ACK/NAK
. XFER32 defaults to the
XModem
and
Protocol are the only two protocols
Errors
1
50
to
.
is the default. Use either
is not supported by the PT40.
Protocol is NOT supported by the Falcon PT40.
ZModem
Request to Send
(
) serial port lines to communicate when to
CTS
Protocol is NOT supported by the Falcon PT40.
ZModem
as
protocol unless you
ZModem
Protocol.
permitted before a file
0
specifies no limit to the
None
RTS/CTS
or
protocol.
(
), and
RTS
protocol.
®
Falcon
PT40
.