Log Set Installation; Optional Brick Panels; Log Installation - Masport FireGenie PG33-NG Owners & Installation Manual

OPTIONAL BRICK
PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
2) Attach the 2 Rear Brick Retaining clips to
the rear wall. Loosen the screws in the top
and rear wall of the firebox and slide the
retaining clips into position (tight against
the firebox top) and then tighten the screws.
Note: The logs must not be in the unit.
3) Insert the back brick panel by carefully
slipping it between the back wall of the
firebox and the rear log bracket.
4) Put the side panels in next. Slide them in from
the front and push them flat up against the
wall. Be very careful not to scratch them on
the firebox hardware.
5) Slide the Top Brick Panel into position and
slide the Top Brick Retaining clips so that
they hold the Top Brick Panel in place and
tighten down the screws.
Masport PG33 Gas Inbuilt

LOG SET INSTALLATION

Read the instructions below care-
fully and refer to the diagrams. If
logs are broken do not use the
unit until they are replaced. Bro-
ken logs can interfere with the
pilot operation.
The 3-digit numbers (i.e. 250) are
molded into the rear of each log.
Log Kit # 431-930 contains the following pieces:
A ) 250 Rear Log
B) 254 Middle Cross Log
C) 253 Front Left Cross Log 902-253
D) 251 Rear Left Log
E) 252 Front Right Cross Log 902-252
F) Embers
G) Vermiculite
H) Rockwool
NOTE: If you will be installing the optional
Brick Panels, install the Brick Pan-
els prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite and embers around
the firebox base.
Vermiculite
Vermiculite
3) Place the Log 250 on the rear log support
pins with the flat side to the back.
250
INSTALLATION
D) 251
B) 254
C) 253
4) Place Log 254 on the front right side of the
burner. Push the back of the log against the
902-250
2 brackets with the notch on the bottom
902-254
right side of the log fitting into the right side
of the grate.
902-251
902-156
902-179/21
902-153
Bracket
250
254
5) Position Log 253 across the cutouts in Logs
250 and 254 with the notch on the left side
Vermiculite
of the log fitting into the 2nd grate tab.
2nd Grate Tab
A) 250
E) 252
Notch
254
Bracket
Cutouts
253
250
254
33