Horizontal Terminations Only - Masport FireGenie PG33-NG Owners & Installation Manual

Table of Contents

This flueing system, in combination with the PG33 Direct Flue Gas Fireplace, have been tested and listed as a direct flue heater system by AGA.

The location of the termination cap must conform to the requirements in the Flue Terminal Locations diagram on page 10.

Masport Direct Flue (Flex) System Termination Kit (Part # 946-513) includes all the parts needed to install the PG33 with a maximum

run of 2 feet. If installing the P33 with a continuous flue length of more than 2 ft (.6m) to a maximum of 10 ft. (3.0m) using Kit # 946-515 (4 ft)

or 946-516 (10 ft) or see page 13 for alternate flueing arrangements.

1) 6-7/8" dia. flexible liner (2 ft. length)

2) 4" dia. flexible liner (2 ft. length)

3) spring spacers (3)

4) thimble (2)

5) AstroCap termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" drill point, stainless steel (4)

Notes:

1) Liner sections should be continuous without

any joints or seams.

2) Only Flex pipe purchased from Masport may

be used for Flex installations.

IMPORTANT

If using any Cabinet Mantels with Part # 510956, 510958,

510962, 510964 and 510834 the wall thimble must be

secured first and flueing must be attached to unit before

sliding into final position.

Also Simpson Dura-Flue flueing cannot be used with any

of the mantels noted above.

Minimum Flex Kit Center-Line

(NG & LPG)

Masport PG33 Gas Inbuilt

MASPORT DIRECT FLUE SYSTEM (FLEX)