Conversion To Lpg - Masport FireGenie PG33-NG Owners & Installation Manual

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Conversion Kit 436-969 Contains:
Qty. Part # Description
1 904-163 Burner Orifice #54
1 908-528 Red "LPG" label
2 908-255 Label "Converted to LPG"
1 918-333 Instruction Sheet
1 910-920 LPG Pilot Orifice
1) Shut off the gas supply and unplug the
power cord.
2) Carefully remove the glass, logs and lava
rock.
3) Remove burner.
4) Remove burner orifice with a 1/2" wrench
and discard. Use a wrench to hold on to the
elbow behind the orifice.
5) Reinstall new burner orifice stamped #54
and tighten.
Burner Orifice
6) Remove the rear log tray.
7) Remove the 2 screws which secure the
pilot.
Rear Log Tray
8) Lift the pilot assembly and remove the pilot
tube from the pilot assembly using a 11mm
wrench.
Masport PG33 Gas Inbuilt
Conversion Kit #436-969 for NG to LPG
9) Remove the NG pilot orifice and replace it
with the LPG orifice.
Pilot Pilot
Tube
Extrusion
Tube
10) Re-install the pilot tube to the pilot assembly.
11) Re-install the pilot assembly over the pilot
extrusion tube and secure it with 2 screws.
12) Re-install the rear log tray.
13) Adjust the burner aeration setting to
12.7 mm and re-install the burner.
14) Open the bottom louvre.
15) Stick the conversion label "This unit has
been converted to LPG" over top of the
serial number decal.
16) Replace the yellow "NG" label with the red
"LPG" label.
17) Remove the screw from the module and pull
off the module cover.
screw
18) Pull out the 2 orange wires attached to the
valve, and the connector from the module.
orange
connector
wires
19) Carefully pull out the control box.
20) Remove the heat sheild from the control
box by removing the 2 screws.
NOTE: The control box is held in place with
velcro.
Pilot
Pilot
Assembly
Orifice
heat sheild
21) Remove the control box cover by undoing
the 3 screws. Maneuver through antenna.
22) Remove the jumper using a plier.
Control Box
module cover
Jumper
connector
INSTALLATION
control box
Antenna
Cover
Jumper Location
27