4.9 Bluetooth module
Installing the Bluetooth module
The following describes the procedure for installing the Bluetooth module (See Figure 4-16).
1. Connect the Bluetooth flat cable to the connector CN4400 on the system board.
2. Connect the Bluetooth flat cable to the connector on the Bluetooth module.
3. Install the Bluetooth module into the slot.
4. Connect the Bluetooth antenna cable to the connector on the Bluetooth module.
5. Stick the glass tape in place.
QOSMIO G40 Maintenance Manual (960-632)
Downloaded from LpManual.com Manuals
4 Replacement Procedures
[CONFIDENTIAL]
4-27