Procedure 3 Connector Check And Replacement Check - Toshiba QOSMIO G40 Maintenance Manual

2.5 USB FDD Troubleshooting
Procedure 3
USB FDD is connected to USB port on system board. The connection of the cable and board
may be defective. Otherwise, they may be faulty. Disassemble the computer following the
steps described in Chapter 4, Replacement Procedures and perform the following checks.
USB FDD can be connected to the following 5 ports.
(System board x 4 ports and Sound/USB Jack board x 1 port)
Check 1
NOTE: When checking the connection, be sure to check it with care for the followings.
1. Cable can not be disconnected from the connector.
2. Cable is connected straight to the connector.
3. Cable is connected all the way seated in the connector.
4. Cable or connector can not be broken.
QOSMIO G40 Maintenance Manual (960-632)
Downloaded from LpManual.com Manuals
Connector Check and Replacement Check
Make sure USB FDD is firmly connected to USB port. If the connection is loose,
connect firmly and repeat Procedure 2. If the problem still occurs, go to Check 2.
2 Troubleshooting Procedures
[CONFIDENTIAL] 2-41