Toshiba QOSMIO G40 Maintenance Manual page 326

4 Replacement Procedures
Installing the Volume board
The following describes the procedure for installing the volume board (See Figure 4-63 and
4-64).
1. Turn the knob of the volume board 90 degrees in the direction in the figure below.
2. Install the volume lens to the volume board while engaging the latches.
3. Turn the volume dial 90 degrees in the direction in the figure below and install the
volume dial to the volume board assembly.
4. Turn up the insulator and install the volume board assembly to the cover assembly
with the volume board assembly under the guide.
5. Secure the volume board assembly with the following screws.
6. Arrange the volume cable in place while passing the hole of the insulator.
4-88
Downloaded from LpManual.com Manuals
Volume dial
Volume lens
Latch
Volume board
Figure 4-64 Assembling the volume board assembly
• M2.5×4B FLAT HEAD screw
[CONFIDENTIAL]
Latch
×2
QOSMIO G40 Maintenance Manual (960-632)
4.34 Volume board
Knob