Dhw Temperature Set-Point; Boiler Control Setting - REMEHA Gas 110 Eco 115 Installation And Service Manual

4.5.3

DHW temperature set-point ( )

The DHW temperature is adjustable from 20 to 75 °C (factory default
55°C). Only with Broag DHW priority sensor.
- Press the -key until the digit
" "
code -display.
" "
- Press the -key until the digit
" "
code -display.
" "
- Set the required value, using the [+] and [-] -keys.
4.5.4

Boiler control setting ( )

The boiler is factory set to option
with DHW on).
To change the control option:
- Press the -key until the digit
" "
code -display.
" "
- Press the -key until the digit
" "
code -display.
" "
- Set the required X and Y values as listed below in using the [+] and
[-] -keys.
- Press the -key to store the new value (value will flash twice).
" "
- Press the reset -key to return to operating mode.
" "
-display
First segment
Second segment
* NOTE: boiler setting
20
(with dot) appears in the
(with dot) appears in the
(HTG modulating or on/off
(with dot) appears in the
(with dot) appears in the
Description
Boiler control option
Boiler enabled internal modulation with booster on *
Boiler high/low
Boiler enabled internal modulation with booster off *
Analog signal 0 - 10 V on temperature
Analog signal 0 - 10 V on output %
Operation mode
HTG and DHW off
HTG and DHW on
HTG on and DHW off
HTG off and DHW on
and have the same function
Gas 110 Eco 115 / 65
- Press the -key to store the new value (value will flash twice).
" "
- Press the reset -key to return to operating mode.
" "
REMARK: there are further adjustments available on service level.
Please refer to your service engineer or contractor
See chapter 4.6.7.
With the code - display showing
" "
method of boiler control in the first segment
turn the HTG and DHW on or off in the second segment
using codes from the table below a series of control options are
available.
Example:
- Boiler enabled internal modulation with booster on * - HTG
and DHW on (as default)
- Analog signal 0 -10 V on temperature - HTG on and DHW
off
- Boiler high/low - HTG off and DHW on
- the -display will indicate the
and the option to
. By
26/01/2009 - 300014883-001-F