Dhw Temperature Set Point - REMEHA Quinta 85 Technical Information

6.6 Setting mode service level (X00)
6.6.1 Flow temperature set point during forced part load ($)
6.6.2 High limit thermostat (%)
6.6.3 Fan speed at full load HTG (^)
6.6.4 Fan speed at part load (HTG and DHW - &)
6.6.5 Starting point modulation (*)
6.6.6 Interface selection (()
6.6.7 DHW cut-in temperature (B)
6.6.8 Fan Speed at DHW full load (C)
6.6.9 Forced part load time after start (HTG only - G)
6.6.10 DHW control stop set point (I)
6.6.11 DHW control option (J)
6.6.12 HTG cut in temp (N)
6.6.13 Boiler type (P)
6.6.14 Maximum delay time (U)
6.6.15 Start and end point analog signal (Q and Y)
6.7 Read-out mode (X00)
6.8 Fan speed mode (<00)
6.9 Failure mode (x00)
7 Installation instructions
7.1 General
7.2 Location
7.3 Flue gas discharge and air supply
7.3.1 General
7.3.2 Classification due to discharging flue gases
7.3.3 Material and installation
7.3.4 Single boiler conventional flue
7.3.5 Single boiler, room sealed flue
7.3.6 Different pressure zones
7.3.7 Modular installations
7.4 Hydraulic installation
7.4.1 Condensate and AAV discharge
7.4.2 Water treatment
7.4.3 Cold feed and expansion tank height for open vented systems
7.4.4 Safety valve
7.4.5 Gas connection
7.4.6 System pump
7.4.7 Waterflow
7.5 DHW production
3
23
25
25
25
25
25
26
26
26
26
27
27
27
27
27
28
28
29
29
30
30
30
31
31
32
33
33
34
35
36
36
36
37
38
38
39
39
39
39