Technical Characteristics; Boiler; Control Panel - REMEHA Gas 110 Eco 115 Installation And Service Manual

3.4 Technical characteristics

3.4.1

Boiler

- For operation on Natural Gas or Propane (See "Switching from
Natural Gas to Propane")
- The boiler is preset in the factory to operate on natural gas G20,
20 mbar (minimum 17 mbar)
- The boiler is suitable for room sealed or open flue applications
- Monoblock heat exchanger in cast aluminium/silicium
- Cylindrical premix burner covered in metal fibres
3.4.2

Control panel

Please read the following installation and commissioning
instructions carefully before operating your equipment. The
manufacturer shall not be liable for damage caused by the
failure to comply with these instructions and the warranty shall
no longer apply.
If work is carried out on the heating installation: assembly,
commissioning, maintenance and repair work on the
appliance and on the heating installation must be carried
out only by a qualified heating professional.
Before installation : Ensure that the mains power supply is
isolated.
Before commissioning : Check the seal on the gas and
water pipe connections.
The connection of the control panel must be carried out by
a qualified professional. For a proper operating of the
boiler, follow carefully the instructions.
- Power supply : 230 V (±10%) - 50 Hz
26/01/2009 - 300014883-001-F
- Centrifugal fan with combustive air intake silencer for a low noise
level
- Compact gas line with zero pressure regulator, two valves and filter
- Water condensation siphon with run-off pipe
- Automatic air vent
- Mechanical manometer
- Soundproofed boiler body
- A documentation pack.
Gas 110 Eco 115 / 65
9