Control And Safety Equipment; Control Panel; General; Layout Of The Control Panel - REMEHA Gas 110 Eco 115 Installation And Service Manual

4 Control and safety equipment

4.1 Control panel

4.1.1

General

The boiler is supplied with a standard set of defaults pre-programmed
for normal operation but can be tailored by the Engineer to suit most
site conditions. These values are set and read using the built in
control panel or with a notebook computer/PDA (with an interface
and software available from Broag).
4.1.2

Layout of the control panel

a. "code"-display
Indicates on user level:
Additional indication on service level:
b. -display
Indicates:
c. reset-key:
d. " "-key:
e. " "-key:
e. -key + -symbol:
f. " "-key:
f. -key + -symbol:
g. [+]-key:
g. [+]-key + -symbol:
h. [-]-key:
h. [-]-key + -symbol:
14
Operating mode: only one digit
Setting mode: digit with dot
Read-out mode: digit with flashing dot
Shut-off mode: letter
Forced full load: letter
Forced part load: letter
Speed mode: alternate half digit
Failure mode: flashing digit
Temperatures, settings, fault codes (flashing digits), shut-off codes (flashing dots)
To reset after a lockout condition
Program function: key to select the required mode
Program function: key to select the required program within the selected mode
Switch function: burner switch HTG (manual override)
Program function: key to save the settings
Switch function: burner switch DHW (manual override)
Program function: to select a higher setting
Switch function: pump manual override
Program function: to select a lower setting
Switch function: manual override (hand/auto)
Gas 110 Eco 115 / 65
For security the control has three levels of access:
- User level - free access
- Service level - access with service code by qualified personnel
- Factory level - access by PC with factory code (Remeha only).
26/01/2009 - 300014883-001-F