Uni-D/Bi-D Low/High Adjustment - MUTOH ValueJet VJ-1604 Maintenance Manual

VJ-1604 Maintenance Manual
240 CW
320 CW
240 CCW
320 CCW
* Print pattern: Uni-D, 2 pass, 1A to 2B print
1st pass: prints middle dot
2nd pass: prints small dot
5.7.5

Uni-D/Bi-D Low/High Adjustment

Adjusts the gap of the print heads (in the CR moving direction) when the head is in the PG Low/High and the
print position of the head in repeatability printing.
To adjust, perform printing in repeatability printing and correct CW and CCW printing positions by inputting
parameters.
* Check the plotout at the origin, center and the opposite side to origin, and perform adjustment so that the
gap is even.
Adjustment items are shown below.
Item
Uni-D 240
Uni-D 320
Uni-D 240B
Uni-D 320B
Bi-D 240
Bi-D 320
Bi-D 240B
Bi-D 320B
Item
Set up
Print (when Bi-D is
selected, Print 1 is
displayed)
Items
CW 240 CPS
CW 320 CPS
CCW 240 CPS
CCW 320 CPS
Table 5-8 Uni-D / Bi-D menu items
Adjusts CW at 240 CPS. PG Low or High
Adjusts CW at 320 CPS. PG Low or High
Adjusts CW at 240 CPS-Banner. PG Low or High
Adjusts CW at 320 CPS-Banner. PG Low or High
Adjusts Bi-D at 240 CPS. PG Low or High
Adjusts Bi-D at 320 CPS. PG Low or High
Adjusts Bi-D at 240 CPS-Banner. PG Low or High
Adjusts Bi-D at 320 CPS-Banner. PG Low or High
Table 5-9 Uni-D / Bi-D adjustment items
Sets the selected parameter.
Prints pattern according to the selected item with the
current parameter.
Speed
Contents
Contents
5-33
5 Self-Diagnosis Mode
Rev.-00