Table of Contents
Advertisement
[UPnP]
•
Port number(HTTP), Port number(HTTPS): The port number that is set for UPnP port forwarding will be
displayed.
•
Status: The port forwarding status will be displayed.
•
Router global address: The global address of router will be displayed.
[Self check]
The self check result of the hardware will be displayed.
Note
•
Refer to our website (http://panasonic.net/pss/security/support/info.html) for further information about
the contents of the displayed statuses (relating to the "Viewnetcam.com" service, the UPnP function,
or the self check).
15.4 Reset the settings/Reboot the unit [Default
reset]
Click the [Default reset] tab of the "Maintenance" page. (®page 21, page 23)
The settings and the HTML data of the unit can be initialized and reboot of the camera and unit can be
performed on this page.
[Reset to the default (Except the network settings)]
Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset.
It is impossible to operate the unit for about 3 minutes after the initialization.
[Load the default HTML files (setup menu).]
Click the [Execute] button to reset the HTML files to the default.
It is impossible to operate the unit for about 3 minutes after the initialization.
[Reset to the default and load the default HTML files.]
Click the [Execute] button to reset the settings of the unit and the HTML files to the default. Note that the
network settings will not be reset.
It is impossible to operate the unit for about 3 minutes after the initialization.
[Camera restart]
Click the [Execute] button to reboot the camera connected to the unit. You will not be able to operate the camera
for approximately 1 minute after the reboot.
Because reboot is performed by "RS485 transmission", the RS485 cable must be connected and "On" must
be selected for "RS485 transmission". (®page 41)
15 Maintenance of the unit [Maintenance]
Operating Instructions
109
Advertisement
Table of Contents
