Table of Contents
Advertisement
•
When the [Network Settings] button is clicked, the "Network Settings" screen is displayed and
network settings can be changed. For further information, refer to page 117.
3.
The viewer software "Network Camera View 4S" must be installed in order to view images. Follow the
on-screen instructions to install the software.
•
The "Live" page of the unit is displayed.
Changing Network Settings
When changing settings related to the network settings, such as connection mode, IP address, and subnet
mask, click the [Network Settings] button in [IP Setting Software] screen.
The "Network Settings" screen is displayed. Enter each item and then click the [Save] button.
Note
•
By unchecking the "Wait for camera restarting." checkbox, multiple cameras can be continuously
configured.
•
For further information about each setting of the "Network Settings" page, refer to page 66.
IMPORTANT
•
It may take for around 2 minutes to complete to upload the settings to the unit after clicking the
[Save] button. The settings may be invalidated when the LAN cable is disconnected before
completing the upload. In this case, perform the settings again.
•
When using a firewall (including software), allow access to all UDP ports.
18 Using the CD-ROM
Operating Instructions
117
Advertisement
Table of Contents
