Table of Contents
Advertisement
8 Configure the settings relating to images [Image]
8.4 Configure the settings relating to image and
positions [Image/Position]
Click the [Image/Position] tab on the "Image" page. (®page 21, page 23)
The image quality and position settings can be configured on this page, by displaying the setup menu on the
image using the camera connected to the unit and RS485 communication.
Note
•
It is necessary to connect the RS485 cable of the camera to the unit and to set RS485 on the
[RS485] tab on the "Image" page. (®page 41)
•
Refer to the manuals provided with the camera for the camera setup menu.
•
Image/Position adjustment function is activated for the angle of view in "VGA [4:3]" even when "VGA
[16:9]" is selected for "Picture (Camera) mode". Because a part of the connected camera's setup menu
will not be displayed in this case, we recommend changing the "Picture (Camera) mode" setting to
"VGA [4:3]". (®page 32)
Example: when the connected camera is WV-CW590
A
Display the camera's setup menu on the image, and use each button to perform operations as necessary. The
displayed setup menu differs depending on the connected camera.
[Menu] buttons
•
[On] button: Click this button to display the setup menu of camera.
•
[Off] button: Click this button to close the setup menu of camera.
Arrow buttons/[Set] button
•
/
•
/
•
[Set] button: Click this button to move the submenu.
40
Operating Instructions
B
C
D
E
: Click these buttons to move the cursor.
: Click these buttons to select the parameters.
F
G
H
Advertisement
Table of Contents
