Table of Contents
Advertisement
The settings relating to the FTP server used to transmit the alarm images can be configured on this page.
[FTP server address]
Enter the IP address or the host name of the FTP server.
•
Available number of characters: 1 - 128 characters
•
Available characters: Alphanumeric characters, the colon (:), the period (.), the underscore (_), and the
hyphen (-).
•
Default: None (blank)
IMPORTANT
•
When entering the host name for "FTP server address", it is necessary to configure the DNS settings
on the [Network] tab of the "Network" page. (®page 66)
[User name]
Enter the user name (login name) to access the FTP server.
•
Available number of characters: 1 - 32 characters
•
Unavailable characters: " & : ; \
•
Default: None (blank)
[Password]
Enter the password to access the FTP server.
•
Available number of characters: 0 - 32 characters
•
Unavailable characters: " &
•
Default: None (blank)
[Control port]
Enter a control port number to be used for the FTP server.
•
Available port number: 1-65535
•
Default: 21
The following port numbers are unavailable since they are already in use.
20, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[FTP mode]
Select "Passive" or "Active" for the FTP mode.
Normally, select "Passive". When it is impossible to connect after select "Passive", try to connect after selecting
"Active".
•
Default: Passive
12 Configure the settings of the servers [Server]
Operating Instructions
63
Advertisement
Table of Contents
