Relay Setting; Alarm Setting - Avermedia NV 3000 User Manual

5.8

Relay Setting

The I/O device must be installed to use this function.
To set the Relay Setting:
1. Click the drop-down list and select the relay ID number.
2. Enter relay name.
3. The system automatically detects the card and input
number. In the Content section, enter relay description.
4. In the test section, click Test to trigger relay. Red is
high and Green is low.
5. Click OK to exit and accept the setting and Cancel to
exit without saving the setting.
5.9

Alarm Setting

In the Alarm Setting dialog box, click Add to insert and set new alarm setting, click Delete to
remove the selected alarm setting, click OK to exit and save the setting, Cancel to exit without
saving, and Default to revert back to original factory setting.
(1)
(2)
(3)
(4)
(5)
To set the Alarm Setting:
(6)
82
(7)