Table of Contents
Advertisement
4.9. Resetting the System
This will restore all settings to default. It will delete all remotes and detectors from the
system.
This should be done if both remotes are lost.
a) Remove the Watchguard Home Alarm System from the wall or eve, so the
tamper switch is not depressed.
b) Turn the key switch to off then back on again.
c) Within 15 seconds of turning the keyswitch to on, press in the tamper switch, 20
times. NOTE: On system power up the tamper will not respond for the first 15
seconds.
d) When the system begins to beep hold down the button 1 on the remote control
you wish to use with the system. Keep it pressed until the beeping stops. This
remote is now learnt in and everything is set back to default and all detectors
need to be re learnt in. You will need to learn in any additional remote controls.
33
Advertisement
Table of Contents
