System Setting; Password Setting; System Upgrade - Watchguard DVR4ENTPACK4 Manual

5.6 System Setting

5.6.1 Password Setting

Right-click to display the main menu, and select "SYSTEM"  "TOOLS"
TOOLS
SYSTEM INFO
USB BACKUP
EXIT
1) ADMIN PASSWORD
Click "SETUP" to change the administrator password. The default administrator
password is 0000. When you're prompted to enter the DVR password, enter the
administrator password, and
operations are allowed.
2) OPERATOR PASSWORD
Click "SETUP" to set or change the operator password. When you're prompted to enter the
DVR password, enter the operator password and
screen. Using an operator login means that the main menu CANNOT be accessed.

5.6.2 System Upgrade

Note:
Performing a DVR system upgrade might cause all HDD data to be cleared. This usually occurs if your
current system version is too old for the latest version. Therefore, before upgrading the DVR
system, check your current firmware version with your installer or distributor, and make a video
backup if necessary.
Right-click to display the main menu, and select "SYSTEM"  "TOOLS"  "UPGRADE"
Save the upgrade files obtained from your installer or distributor onto a compatible USB
flash drive, and insert it into the USB port at the front panel.
Then, click "SUBMIT" to start upgrading.
Note:
Before using the USB flash drive, please use your PC to format the USB flash drive to FAT32
format. For the list of compatible USB flash drives, please refer to "APPENDIX 2 COMPATIBLE USB
FLASH DRIVE LIST" on page 48.
SYSTEM
LANGUAGE
ADMIN PASSWORD
OPERATOR PASSWORD
UPGRADE
will be shown on the status bar of the screen and all
24
FREQUENTLY-USED FUNCTIONS
ENGLISH
SETUP
SETUP
SUBMIT
will be shown on the status bar of the