28
4.5. Walk Test Mode
Walk test mode should be used when testing the system or after a new detector has
been learnt into the system.
TO ENTER WALK TEST MODE
1.
Safety Lock must
be off
2.
Press both buttons
for 3 seconds
3.
Press 1 time
4.
Press 1 time
5.
Walk Test mode
6.
Press 1 time to exit
Ensure Safety Lock has been turned off within the last 5
minutes. See Section 4.2.
Enter Programming mode by pressing buttons 1 & 2
together for 3 seconds. The siren will beep 3 times to
confirm you have entered programming mode.
Within 3 seconds, press Button 2 to select special
features. You will hear 2 beeps as confirmation.
Within 30 seconds, press Button 2 to enter Walk Test
mode. You will hear 2 beeps as confirmation.
The system will enter Walk Test mode. During this time,
the siren will beep the number of times of the zone which
has been triggered. Detectors which have been set to 24
hour mode will still trigger the alarm. If the tamper switch
is pressed the siren will beep once.
Press Button 2 to exit Walk Test mode.
-