Table of Contents
Advertisement
8
2.2. The Main Unit
Mount the Watchguard main unit at the front or front side of the building. The
mounting position should be under an eave or out of direct contact with rain or other
water sources. The position should allow line of sight viewing from both the street (for
visual deterrent) and from your main point of entry (for visual confirmation of
arming/disarming).
Use the wall plugs and screws provided if suitable for your particular building
construction.
Figure 2
Figure 3
Installing the main unit
1. Drill mounting holes (7mm diameter,
25mm minimum in depth) into the
chosen wall.
2. Use the green star plug. Press each
one into the 4 main mounting holes.
3. Make a hole and push the wires
through the wall and up into the
ceiling.
4. Screw the top 2 screws half way in.
5. Place the unit to support itself from
the top 2 screws through the key
shape holes at the top of the main
unit
6. Screw in and tighten the bottom two
mounting screws then tighten the top
two screws.
Advertisement
Table of Contents
