30
4.7. Stay Mode Entry Guard Sound
This selects the type of sound you would like for the stay mode alarm. There are 2
options. Normally, if the alarm is triggered in stay mode the alarm will sound 6 tones
when set to Entry Guard Tones. This is used to alert you if someone enters within
the stay mode protected area while you are at home. After hearing the entry guard
tones you may, if you choose, activate panic via the remote control. You can also
choose to have it sound Full Siren when an active stay zone is triggered. This only
applies to STAY mode.
Default
Entry Guard Tones
TO CHANGE THE STAY MODE ENTRY GUARD SOUND
1.
Safety Lock must be
off
2.
Press both buttons
for 3 seconds
3.
Press 1 time
4.
Press 1 time
Continued on next page...
Option 1
Full Siren
Ensure Safety Lock has been turned off within the last 5
minutes. See Section 4.2.
Enter Programming mode by pressing buttons 1 & 2
together for 3 seconds. The siren will beep 3 times to
confirm you have entered programming mode.
Within 3 seconds, press Button 1 to select detector
programming. You will hear 1 beep as confirmation.
Within 30 seconds, press both Button 1 & 2 together to
select the STAY mode entry guard sound. You will
hear 3 beeps as confirmation.