Adding New Remotes - Watchguard N517Series II User Manual

4.1. Adding New Remotes

TO ADD A NEW REMOTE
1.
Press 1 time
2.
3.
Siren beeps 9 times
4.
Press new remote
control for 3 secs.
5.
Press new remote
control to test
Your Watchguard Home Alarm System can only store a maximum of SEVEN (7)
remotes in its memory. If you learn in an 8th remote, the 1st remote control will be
erased. If you loose a remote control, or have one stolen, simply repeat the procedure
above with your remaining remotes at least 10 times. This will ensure that you have
erased the lost remote from the memory of your Watchguard Home Alarm System.
Disarm the system (if it is not already disarmed) with an
original remote control by pressing Button 2. You do not
need to enter programming mode.
Press and hold Button 2 (for approximately 3 seconds) on
the original working remote control until the siren starts
to beep continuously, then release the button.
The main unit will beep 9 times to confirm you are
adding a new remote control.
As soon as the beeps finish, press and hold down button
2 on the new remote control for 3 seconds.
The new remote control is now programmed into the
alarm. To confirm this press Button 1 on the new
remote to ensure it arms the system.
If this new remote doesn't work restart this procedure
from the start.
23
+