Adding A Detector - Watchguard N517Series II User Manual

4.3. Adding a Detector

TO ADD A DETECTOR
1.
Safety Lock must
be off
2.
Press both buttons
for 3 seconds
3.
Press 1 time
4.
Press 1 time
5.
Open the detector
you wish to add
Continued on next page...
Ensure Safety Lock has been turned off within the last 5
minutes. See Section 4.2.
Enter Programming mode by pressing buttons 1 & 2
together for 3 seconds. The siren will beep 3 times to
confirm you have entered programming mode.
Within 3 seconds, press Button 1 to select detector
programming. You will hear 1 beep as confirmation.
Within 30 seconds, press Button 1 to ADD a detector.
You will hear 1 beep as confirmation.
Trigger the detector to be added. If you are learning a
Passive Infrared detector remove the front cover or press
the tamper switch then release. Learning mode will
timeout in 60 seconds. When the system has successfully
received the code from the detector, the siren will beep the
number of times of the zone that the detector has to learn
into and will do so whenever any unlearnt detector
transmits.
25
+