Powering Up; Booting With Primary Or Recovery Operating System; Figure 2-3 Plugging In A Hybrid Lt Dvr - Honeywell Rapid Eye Hybrid LT Installation Manual

Powering Up

Booting with Primary or Recovery Operating System

Document 800-07766V4 Rev A
01/2013
Figure 2-3 Plugging in a Hybrid LT DVR
Connect power
supply from camera
to UPS
Connect power supply
from UPS to DVR
During the two minutes, or so, that the DVR needs to initialize, it is good practice to NOT
turn it off (see Unit Recovery, page 33).
1. Plug the Rapid Eye Hybrid LT DVR and its cameras into a power source, preferably an
uninterruptible power supply (UPS).
2. Turn on camera(s) and other hardware connected to the DVR.
3. Press the power switch on the back panel of the Hybrid LT DVR. If you have a
LocalView monitor connected (see
the Primary or Recovery system boot (see
System on page 31). If no choice is made, the Primary Operating System boot is
selected and executed after 5 seconds.
Note Honeywell recommends that you power the cameras before powering the
Rapid Eye Hybrid LT DVR. This should ensure all the cameras are detected
by the unit when it powers up.
Rapid Eye users have two options for booting the operating system. When powering the
unit, users have the option of booting the OS from either the primary or recovery hard
drives. If no selection is made, the primary system boot is selected by default and is
automatically executed after 5 seconds.
Rapid Eye™ Hybrid LT DVR Installation Guide
VIDEO connector on
analog camera to
VIDEO INPUT on DVR
SPOT
MONITOR
1 2 3 4 5 6
VIDEO
INPUTS
TELCO
SERIAL PORT 2
LAN
SERIAL PORT 1 VGA
USB USB
Monitor on page 35) you have the choice of using
Booting with Primary or Recovery Operating
C OMMO N CONTROL
SYS FAIL
OUTPUTS SERIAL
SYS GOOD
1 G 2 G 3 G 4 G
PORT 3
FAULT
RELAY
7 8 28V, 3A
MAX
SERIAL
PORT 4
5 G 6 G 7 G 8 G
1 G 2 G 3 G 4 G
ALARM INPUTS
IN
ON/OFF
OUT
115-230V~
50/60 Hz
NOT
5-3A
USED
POWER
31