Figure 2-2 Analog Camera Connections To A Hybrid Lt Dvr - Honeywell Rapid Eye Hybrid LT Installation Manual

Document 800-07766V4 Rev A
01/2013
Note Rapid Eye Hybrid LT DVRs support up to 4/8 Honeywell equIP
®
H.264, equIP
and/or HD3/4 IP cameras on Rapid Eye Hybrid LT V10.1 units. Some ONVIF
IP cameras are also supported (see
for a complete list of IP cameras supported by Rapid Eye Hybrid LT V10.1 and
V10.0 DVRs).
Caution Power down the DVR before connecting hardware to it. See
Hybrid LT DVR
Figure 2-2 Analog Camera Connections to a Hybrid LT DVR
SPOT
MONITOR
1 2
VIDEO
INPUTS
Connect the analog cameras sequentially; that is, connect the first camera to VIDEO INPUT
1, the second camera to VIDEO INPUT 2, and so on.
The BNC connector's low signal loss, ease of twist-on installation, and small size, make it
a common connector for CCTV connections. Honeywell recommends using a solder- or
crimp-type connector.
Video is quite sensitive to bad connectors; do not use screw-type connectors. These can
seriously compromise the performance of your DVR.
Note If you are using Honeywell and/or supported ONVIF IP cameras in your
system, you must decide what channels you want the IP camera(s) to use
(Video Input 1, 2, or 3, and so on). Make sure the video input connections on
the back panel for the chosen channel(s) are not being used by any analog
cameras if they are going to be used for IP cameras.
Rapid Eye™ Hybrid LT DVR Installation Guide
®
1080p, equIP Wide Dynamic Range IP, Performance IP,
http://www.security.honeywell.com/hota
on page 30 for more information.
8-channel Rapid Eye Hybrid LT unit
1 2 3 4 5 6 7 8
TELCO
SERIAL PORT 2
LAN
IN
OUT
115-230V~
SERIAL PORT 1 VGA
50/60 Hz
NOT
USED
USB USB
®
V2, equIP
Powering the
COMMON
CONTROL
SYS FAIL
OUTPUTS
SERIAL
SYS GOOD
1 G 2 G 3 G 4 G
PORT 3
FAULT
RELAY
28V, 3A
MAX
SERIAL
PORT 4
1 G 2 G 3 G 4 G 5 G 6 G 7 G 8 G
ALARM INPUTS
ON/OFF
5-3A
POW ER
®
29