Connections And Control Devices; Function Explanations - ESAB Origo M13y YardFeed 200 Instruction Manual

GB
5.1

Connections and control devices

1 Connection for welding current from power
source, (OKC)
2 Connection for shielding gas
3 Connection for control cable from power
source
4 Connection RED, for coolant to power
source (cooling unit)
5 Connection BLUE, for coolant from power
source (cooling unit)
6 Connection RED, for coolant from welding
gun
7 Connection BLUE, with ELP* for coolant to
the welding gun
Note! Display (digital instrument) and coolant connections only available on certain models.
* ELP = ESAB Logic Pump, see point 5.2.
** Voltage regulation from the wire feed unit does not function with step regulated power sources.
5.2

Function explanations

Water connection
The wire feed unit with water connection is equipped with a detection system ELP
(ESAB Logic Pump) which checks that the water hoses are connected. When
connecting a water-cooled welding gun, the water pump starts.
Detection only works with power sources that are equipped with ELP.
Strain relief
Hook the strain relief onto the hook on the rear side of the feeder unit and the
connection cable.
bm47d1ea
8 Safety contact switch
9 Connection for welding gun
10 Toggle switch for gas flushing / wire
inching
11 Toggle switch for 2 stroke/ 4 stroke
12 Display
13 Knob for setting the voltage**
14 Knob for setting wire feed speed
- 9 -
© ESAB AB 2005