Introduction; Equipment - ESAB Origo M13y YardFeed 200 Instruction Manual

GB
Dispose of electronic equipment at the recycling facility!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical and/or
electronic equipment that has reached the end of its life must be disposed of at a
recycling facility.
As the person responsible for the equipment, it is your responsibility to obtain
information on approved collection stations.
For further information contact the nearest ESAB dealer.
ESAB can provide you with all necessary welding protection and accessories.
2

INTRODUCTION

The wire feed unit YardFeed 200 is intended for MIG/MAG welding together with
stepped and thyristor-controlled welding power sources.
It comes in different variants, see page 16.
The wire feed unit contains a four-wheel drive wire feed mechanism as well as
control electronics.
ESAB's accessories for the product can be found on page 20.
2.1

Equipment

The wire feed unit is supplied with:
S
Instruction manual
S
Decal with recommended wear parts
S
Gas flow meter
bm47d1ea
- 6 -
© ESAB AB 2005