Changing Feed Rollers; Maintenance; Inspection And Cleaning - ESAB Origo M13y YardFeed 200 Instruction Manual

GB
5.5

Changing feed rollers

S
Open the side panel.
S
Disconnect the pressure sensor (1) by folding it
backwards, the pressure rollers slide up.
S
Disconnect the pressure rollers (2) by turning the
axle (3) 1/4 turn clockwise and pulling out the axle.
The pressure rollers disconnect.
S
Disconnect the feed rollers (4) by unscrewing the
nuts (5) and pulling out the rollers.
During installation, repeat the above in reverse order.
Choice of track in the feed rollers
Turn the feed roller with the dimensioning mark for the required
track towards you.
6

MAINTENANCE

Regular maintenance is important for safe, reliable operation.
CAUTION
All guarantee undertakings from the supplier cease to apply if the customer attempts any
work to rectify any faults in the product during the guarantee period.
6.1

Inspection and cleaning

Wire feed unit
Check regularly that the wire feed unit is not clogged with dirt.
S
Cleaning and replacement of the wire feed unit mechanism's worn parts should
take place at regular intervals in order to achieve trouble-free wire feed. Note
that if pre-tensioning is set too hard, this can result in abnormal wear on the
pressure roller, feed roller and wire guide.
The brake hub
The hub is adjusted when delivered.
S
Adjust the brake hub so that wire is slightly slack when wire
feed stops.
bm47d1ea
- 12 -
© ESAB AB 2005