AMX MVP-7500 Operation/Reference Manual page 23

IR Emitters
Compact Flash
FIG. 6 Location and orientation of the Compact Flash cards (both MVP panels)
2.
Place the circuit board on a flat level surface so that the IR Emitters are pointing away from you (FIG. 6).
3.
Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either side of the
existing Compact Flash card), and gently pry it out of the slot (FIG. 7). Repeat this process on the opposite card
removal groove. This alternating action causes the pre-existing card to "wiggle" away from the on-board connector
pins.
4.
Slip your finger into the opening (between the connector pins and the card resulting from step 3) and push the card
out.
5.
Finish the process by firmly gripping the exposed sides of the card and pulling it out (FIG. 7). USE CARE WHEN
HANDLING THE CARD.
Card removal
grooves
Insert with arrow
facing towards the pins
FIG. 7 Removing/installing a Compact Flash Memory card
6.
Insert the new card firmly into the slot opening connector (FIG. 7) until the contact pins are completely inside the
card and securely attached to the pin sockets.
MVP-7500/8400 Modero Viewpoint Wireless Touch Panels
Card removal grooves
card
Any new Compact Flash card upgrade is detected by the panel only after the unit
cycles power.
A B
On-board Compact
Flash connector (with pins)
Connector opening
NXA-CFSP Compact Flash
Internal circuit board
(top view - detail)
Wireless Interface
card
9