AMX MVP-7500 Operation/Reference Manual page 72

Setup Pages
Wireless Settings Page (Cont.)
Channel Selection:
Information:
Site Survey:
Information/Configuration: • Mode - Displays the current Security Type selected via either the Simple or
Simple/Enterprise:
Pressing the Simple or Enterprise buttons at the bottom of the Information/Configuration section open an appropriate
Wireless Security window for Simple Mode (FIG. 55) or Enterprise Mode (FIG. 56). Simple Mode is best used for
smaller installations that use a single Master, such as for residences or smaller office environments. Enterprise Mode is
intended for installations that use multiple Masters, where a wireless device may need to switch between multiple
wireless access points connected to different Masters in a network.
58
Pressing this button presents a popup that gives the user the option, in high-
interference areas, of excluding three channel groups in order to find the best
possible connection.
• Channel 1 includes channels 1, 2, and 3.
• Channel 6 includes channels 4, 5, 6, 7, and 8.
• Channel 11 includes channels 9, 10, 11, 12, and 13.
The default on the popup allows scanning on all three channel groups. Click
the checkmark to exclude each channel group: any excluded channel group will
be marked with a red "X".
Pressing this button opens a popup that explains the particular functions of the
Roaming and Channel Selection buttons.
Launches the Site Survey page. The options on this page allow you to detect
("sniff-out") all WAPs transmitting within range of the panel's NXA-
WC80211GCF Wi-Fi card (this feature is not available with the 802.11b).
Data displayed on the Site Survey page is categorized by:
- Network Name (SSID) - WAP names
- Channel (RF) - channels currently being used by the WAP
- Security Type - security protocol enabled on the WAP, if detectable
- Signal Strength - None, Poor, Fair, Good, Very Good, and Excellent
- MAC Address - Unique identification of the transmitting Access Point
• Refer to the Using the Site Survey tool section on page 22 for more detailed
information on the SIte Survey page.
When communicating with a NXA- WAP200G, enter the MAC Address (BSSID)
of the target WAP as the Access Point MAC Address. Refer to the WAP200G
Instruction Manual for more information.
Enterprise options.
• Security Type - Displays whether the currently used security type is Simple
or Enterprise.
• SSID - Displays the currently used SSID of the target WAP.
• Channel - The RF channel being used for connection to the WAP (read-
only).
• Signal Level Value - Displays the quality of the link from the wireless NIC to
the Wireless Access Point (direct sequence spread spectrum) in real time
(None, Poor, Fair, Good, Very Good, and Excellent).Even when link quality is
at its lowest you still have a connection, and the ability to transmit and
receive data, even if at lower speeds.
Note: "Signal Level Value" and "Signal Level" are applicable to RF connections
only. It is possible to have an RF signal to a WAP, but be unable to
communicate with it because of either incorrect IP or encryption settings.
• Signal Level - This bar graph demonstrates the strength of the current
signal.
• Opens either the Wireless Security: Simple Mode or the Wireless Security:
Enterprise Mode windows.
MVP-7500/8400 Modero Viewpoint Wireless Touch Panels