Changing Buzzer Settings - G-Technology G SPEED STUDIO XL Product Manual

G SPEED
STUDIO
with Thunderbolt™
Write Back Cache Flush Interval – Enter a value into the field from 1 to 12 seconds.
Enclosure Polling Interval – 15 to 255 seconds.
• Adaptive Writeback Cache – Check the box to enable or uncheck to disable.
• Forced Read Ahead – Check the box to enable or uncheck to disable.
• Pilot LED Brightness – High, Medium, Low, Off
• Enable HDD Park Ahead(Level 1)
• HDD Park Ahead Interval (10-1440)
• Enable HDD Low Rotation Speed (Level 2)
• HDD Low Rotation Speed Interaval (10-1440)
• Enable HDD Idle Spin Down(Level 3)
• HDD Idle Spin Down Interval (10-1440)
Click the Save button.
3.
4. Click the X icon to close the settings panel.

Changing Buzzer Settings

To change buzzer settings:
1. From the Dashboard icon, select Controller.
2. Mouse-over the buzzer, then click the Settings button.
3. Check the Enable Buzzer box to enable the buzzer or uncheck the box to disable.
4. Click the Save button.
Configuring G-SPEED Studio XL
XL
p. 42